Download PDF Download PDF Print this Page Print this Page Email this Page Email this Page Save to Favorites Save to Favorites

Item # item-1256, Inch Series PLASTITE® 48-2 Screws

Request Information

Plastite® 48-2 Trilobular™ thread-rolling screws have twin lead threads to provide faster, more efficient insertion. The sharp 48° thread profile increases holding strength and reduces material displacement and boss bursting tendencies. Drive and strip torques are higher, making drive tool adjustments simple. NOTE: Component and boss design should allow for much faster engagement than with single lead screws.

Size/TPI – The PLASTITE® 48-2 screw size designation combines the commonly used numerical screw size with the major diameter (Max. "D"), as measured with ordinary micrometers, followed by the number of threads per inch.

Recommended pilot hole sizes are subject to variation dependent on depth of engagement, ease of driving required and material being tapped. Users of PLASTITE® 48-2 screws should perform their own test to determine the most efficient pilot hole size for their own particular use, or contact the application engineering department of a qualified supplier or REMINC.



Request Information

Screw Size T.P.I 8 in - 16
C Dimension 0.179 - 0.185 in
D Dimension 0.173 - 0.179 in
Min. Out-of-Round 0.004 in
Recommended Pilot Hole Size for Soft Ductile 0.149 in
Recommended Pilot Hole Size for Brittle 0.158 in
Materials Low Carbon Steel, Suitably Hardened and Tempered
Finish As Requested
Length Tolerances Thru 3/4" ±0.030"
Over 3/4" ±0.050"
Over 1/4" Dia. All Lengths ±0.050"