Download PDF Download PDF Print this Page Print this Page Email this Page Email this Page Save to Favorites Save to Favorites

Item # item-1269, Inch Series PUSHTITE® II Fasteners

Request Information

PUSHTITE® II Trilobular™ fasteners are designed to be pressed into recommended hole sizes with a single, straight-line stroke. They can be used in a broad range of thermoplastics of widely varying densities.

PUSHTITE® II fasteners combine a 3 lobe thread form with a 70º - 10º semi-buttress thread shape to permit easy entry and provide exceptional pull-out resistance.

Threads are helical, not annular, permitting displaced air to escape during insertion.

The helical thread form also allows the fasteners to be removed and reinserted if necessary.

Recommended length of thread engagement is two screw diameters minimum.

The range of suggested hole sizes is large because of the range of densities in thermoplastic compounds and length of thread engagements. Generally, low density plastic can use smaller hole diameters. Long lengths of engagement (2.5 to 3 diameters) require larger holes.

Tamper Resistant yet Removable for Service.
PUSHTITE® II fasteners are normally available with a drive system in the head for removal, adjustment or final tightening. Where adjustment or removal is not required, they are available without slot, recess or socket in the head.



Request Information

Screw Size T.P.I 9 in - 13
C Dimension 0.175 - 0.181 in
D Dimension 0.168 - 0.174 in
P Point Diameter Ref. 0.134 in
Min. Out-of-Round 0.007 in
Pilot Hole Diameter 0.156 - 0.165 in
Materials Low Carbon Steel, Suitably Hardened and Tempered
Finish As Requested
Length Tolerances Thru 3/4" ±0.030"
Over 3/4" ±0.050"
Over 1/4" Dia. All Lengths ±0.050"